puppet nftables

# nftables puppet module

This module manages an opinionated nftables configuration

By default it sets up a firewall that drops every incoming

and outgoing connection.

It only allows outgoing dns, ntp and web and ingoing ssh

traffic.

The config file has a inet filter and a ip nat table setup.

Additionally, the module comes with a basic infrastrcuture

to hook into different places.

## nftables config

The main configuration file loaded by the nftables service

will be `files/config/puppet.nft`, all other files created

by that module go into `files/config/puppet` and will also

be purged if not managed anymore.

The main configuration file includes dedicated files for

the filter and nat tables, as well as processes any

`custom-*.nft` files before hand.

The filter and NAT tables both have all the master chains

(INPUT, OUTPUT, FORWARD in case of filter and PREROUTING

and POSTROUTING in case of NAT) configured, to which you

can hook in your own chains that can contain specific

rules.

All filter masterchains drop by default.

By default we have a set of default_MASTERCHAIN chains

configured to which you can easily add your custom rules.

For specific needs you can add your own chain.

There is a global chain, that defines the default behavior

for all masterchains.

INPUT and OUTPUT to the loopback device is allowed by

default, though you could restrict it later.

### nftables::config

Manages a raw file in `/etc/nftables/puppet/${name}.nft`

Use this for any custom table files.

## nftables::chain

Prepares a chain file as a `concat` file to which you will

be able to add dedicated rules through `nftables::rule`.

The name must be unique for all chains. The inject

parameter can be used to directly add a jump to a

masterchain. inject must follow the pattern

`ORDER-MASTERCHAIN`, where order references a 2-digit

number which defines the rule order (by default use e.g. 20)

and masterchain references the chain to hook in the new

chain. It's possible to specify the in-interface name and

out-interface name for the inject rule.

## nftables::rule

A simple way to add rules to any chain. The name must be:

`CHAIN_NAME-rulename`, where CHAIN_NAME refers to your

chain and an arbitrary name for your rule.

The rule will be a `concat::fragment` to the chain

`CHAIN_NAME`.

You can define the order by using the `order` param.